2
2
3
7. Clean the oven door with water and soap.
Clean inner side of the door. Dry the oven
door carefully.
When the cleaning is completed, install the
glass panels and the oven door. To install the
oven door, do the above steps in the opposite
sequence.
4
4
5
5
6
Replacing the lamp
Put a cloth on the bottom of the interior of the
appliance. It prevents damage to the lamp glass
cover and the cavity.
WARNING!
Danger of electrocution! Disconnect
the fuse before you replace the
lamp. The lamp and the lamp glass
cover can be hot.
1. Deactivate the appliance.
2. Remove the fuses from the fuse box or
deactivate the circuit breaker.
The back lamp
1. Turn the lamp glass cover counterclockwise
to remove it.
2. Clean the glass cover.
3. Replace the lamp with a halogen, 230 V, 40
W, 300 °C heat resistant lamp.
4. Install the glass cover.
Troubleshooting
WARNING!
Refer to Safety chapters.
What to do if...
Problem
Possible cause
Remedy
You cannot activate the appli-
ance.
The appliance is not connec-
ted to an electrical supply or it
is connected incorrectly.
Check if the appliance is cor-
rectly connected to the electri-
cal supply.
You cannot activate or operate
the hob.
The oven does not heat up.
The fuse is released.
Make sure that the fuse is the
cause of the malfunction. If the
fuse releases again and again,
contact a qualified electrician.
You cannot activate or operate
the hob.
The fuse is released.
Activate the hob again and set
the heat setting in less than 10
seconds.
The lamp does not operate.
The lamp is defective.
Replace the lamp.
www.zanussi.com
13
