13
30
20 min
60
a
b
INSERTION AND ASSEMBLY
The hobs can be installed in a unit having an
opening for installation of the dimensions
illustrated in fig. 11.
The fixture of the hob to the unit must be carried
out as follows:
position the appropriate sealings, supplied, on the
edge of the opening predisposed taking care that
the edges meet without overlapping;
place the hob in the opening of the unit taking
care in centring;
fix the hob to the unit by means of the appropriate
clips (see fig. 12). The traction of the screws is
sufficient to trace the seal, whose excess can thus
be removed. The edge of the hob forms a double
labyrinth seal which provides a total guarantee
against the infiltration of liquids.
POSSIBILITY FOR INSERTION
Kitchen unit with door
Suitable precautions should be taken in the
construction of the unit in order to avoid possible
contact with the hot surround of the hob when in use.
This could occur if the hob surround is affected by a
depression or pressure following the opening or
closing of the door. The solution recommended to
avoid this inconvenience is illustrated in Fig. 14.
The panel under the hob should be easily removable
in order to permit blocking and unblocking of the hob
for technical assistance purposes.
The opening for insertion must be distant from the
base and the side, of a minimum of 55 millimetres for
the rear fig. 18.
a) Seal
480
30
591
380
140
a) Panel of
dismantled
unit
b) Possible
space
useful for
connections
Fig. 14
Fig. 12
Fig. 13
Fig. 15
FO 1013
FO 1038
