30
www.zanussismallappliances.nl www.zanussismallappliances.be www.zanussismallappliances.fr
Removing the coffee grounds
At the end of your use, remove the filter holder from
the appliance. Use the black filter holder flap to block
the filter and throw the ground coffee in the trash.
Preparing frothed milk or hot water
WARNING ! Ensure to place a container
under the steam nozzle when using it.
Otherwise you risk getting burned.
Make sure the steam nozzle is clean
before use.
For any milk-based coffee preparation
(cappuccino, latte, macchiato, etc.), make
sure you prepare your coffee first and then
use the steam mode to reheat or froth your
milk.
If you prepare the coffee after using the
steam mode, wait 5 minutes for the
temperature to drop again.
This espresso machine is designed to dispense
steam for heating water or milk.
1.
Make sure the water tank is filled before using the
steam nozzle. Check that the steam knob controller
is in position 0.
2.
Insert the filter holder into the appliance.
3.
Press on the ON/OFF
, it lights up red and the
espresso dispensing button
flashes white.
The appliance enters preheating mode for a period of
2 minutes.
The required temperature is reached when:
a.
the espresso dispensing button lights
continuously;
b.
and the temperature gauge needle is in
position
.
4.
Press on the steam dispensing button
, it
flashes white.
As soon as the steam dispensing button
emits a
fixed light, place the steam nozzle in a container filled
with liquid (100ml of milk or water) and keep the
nozzle immersed in the liquid to avoid splashing.
Gently
turn
the
steam
knob
controller
counterclockwise to obtain the desired flow rate.
5.
To froth the milk, use a stainless steel milk pitcher
and do the following:
o
fill the pitcher to one third or half of its capacity;
o
immerse the steam nozzle in the milk just below
the surface of the milk and turn the steam knob
controller to the maximum;
o
start by frothing the milk in the bottom of the
pitcher (ensure that the nozzle does not touch the
bottom);
o
place one of your hands under the pitcher or use
a barista thermometer to check the temperature
(the ideal temperature is between 60 ° C to 70 °
C);
o
the milk begins to foam on the surface, gradually
raise your pitcher by plunging the steam nozzle a
little more so that it remains below the level of the
liquid milk. Continue until you reach the desired
volume.
o
our milk is ready when it reaches a temperature
between 60° C and 70° C.
6.
Slowly turn the steam knob controller clockwise to
position 0 when the liquid has reached the desired
temperature or consistency. Press on the steam
dispensing button
to exit the steam mode;
7.
the appliance automatically switches to espresso
dispensing mode. The espresso dispensing button
emits a fixed light.
8.
When using the steam nozzle to prepare frothed
milk or to heat tea, ensure to clean the nozzle
immediately after each use.
Proceed as follows:
o
immerse the steam nozzle in a pitcher filled with
clean water and heat the water with the steam
knob controller on the max position
for 20
seconds;
Summary of Contents for EMZ17-SSB
Page 75: ......
