68
Something not working
l
The flow of gas seems abnormal
l
Gas smell in the room
l
The oven doesn't heat
l
Cooking time is too long
l
The cooker produces smoke
l
The oven lamp doesn't work
If the appliance doesn't work properly check the following points before asking for service:
Make sure that:
the flame speader holes are not obstructed;
the pressure regulator is working;
the bottle valve is completely open.
Make sure that:
the gas valve is not open;
the gas supply tube is well positioned and in good
condition; remember to replace it at least once a
year.
Never look for an escape of gas with a match;
use instead soapy water.
Make sure that the oven knobs are in the correct
worrking positions.
Check that the temperature is correct for the type
of food to be cooked.
We advise you to clean the oven after use.
Splashes of fat can occur during the cooking of
meat and, if the oven isn't cleaned properly, these
produce smoke and bad smell. (see paragraph
concerning cleaning).
The lamp has burnt out. To replace it follow the
instructions given in the relative paragraph.
If, after following all the above checks the appliance still doesn't work, call your nearest Service Centre givin them all
the necessary information, such as model and serial number of the appliance.
Maintenance - Technical assistance
Original spare parts
This machine, before leaving the factory, has been
tested and studied by many experts and specialists, in
order to give you the best results.
Any repair work which needs to be carried out should
be done with the utmost care and attention.
For this reason we reccomend that for any problem you
contact the dealer who sold it to you, or our nearest
authorized Service Centre, specifying the nature of the
problem and the particular model which you own.
Original spare parts, certified by the manufacturer of the
product and marked with the following sign,
can only be found at our approved Technical Assistance
Centres and in authorised Spare Parts Shops.
The gas cocks must be periodically lubricated to ensure
good working and safety.
Maintenance should be performed as follows:
Remove the knob and panel after having taken out
fastening screws.
Loosen the two screws located at the sides of the
cock bar.
Remove the cone and clean it carefully.
Then, apply a thin layer of grease non soluble in
water, suitable for gas cocks. Take care not to
obstruct the gas flow holes by an excess of grease.
Reassemble the whole with utmost care performing the
operations described above inversely.
