Zanotti un0 060, Workshop Manual

Page: 207 / 248

7-196
Annex 1
7.2 Parameters – Multi
Temperature Version
Sensors Configuration Parameter Table
Label Description Udm Value
P2P Environmental probe presence - OFF
P3P Evaporator air delivery probe presence - OFF
Csa Cold room probe calibration °C °F 0 0
CF Measure unit selection
°C °F
C F
Digital Input Management Table
Another column, present in cab command menu, indicates actual sensor state (ON/OFF) read by CPU board.
Label (Sensor) Logic Abilitation J8 Input Pin
High Pressure Switch Op En 13
Low Pressure Switch Op En 2
Clixon cl En 14
Water Temp cl En 8
Oil Pressure cl En 9
Electric Standby Selected cl En 7
Door Open cl Dis 6
Set-Point Comm. cl Dis 5
Thermal Overload protection cl En 12
Door Microswitch Op En 15
Clixon 2 cl En 3
Clixon 3 cl En 3
Defrost Input cl Dis 4
Digital Output Management Table
Another column, present in cab command menu, indicates actual device state (ON/OFF) managed by CPU.
Label (Device) Mode Set State J9 Output Pin
Alarms Aut 2
Heating Aut 4
Evaporator Fans Aut 5
High Speed Aut 6
Electrical Motor Aut 7
Starter Aut 10
Fuel Pump Aut 12
Pre-heating Aut 13
Alternator Aut 14
3 ways valve Aut 3
Partialization Aut 8
Condenser fans Aut 11
Cooling Aut 9
Heating2 or Road mode running Man Off 15
cooling evp2 Aut 2
heating evp2 Aut 1
heating2 evp2 Man Off 6
fans evp2 Aut 3
cooling evp3 Aut 2
heating evp3 Aut 1
heating2 evp3 Man Off 6
fans evp3 Aut 3