Installation
Multitronic-Retrofit Kit_01_2004-06-16
11
►
Connect the sensor cell to the outlet end of the partial flow to be analysed:
Connect the components with the 1/8“ threaded bore (3b), the quick-fit
couplings and the 4-6mm connecting hose.
►
Mount the sensor: remove the protective caps (5, 6)_ and screw sensor (2)
into the cell.
►
Connect the sensor to the signal cable. Place seal onto the sealing face;
connect coupler socket (1) and secure it by tightening the screw.
The coupler socket and the signal cable are factory-wired. For details of the
wiring of the signal cable and the circuit board, see page 13.
Internal connections and switches
The following diagram shows the general layout of the circuit board including
connections.
General wiring diagram of the 4-valve model [5-valve model only available without alarm contact]
Switch S1
