5.7 DC Power Cable Connection
1) Fit the DC Cable
’
s Cord Bushing into the groove of the I/O Bracket, and fasten the I/O
Bracket with a Bolt.
2) Connect the DC Cable Connector to the 4-Pin Connector of the Power Supply.
Note 1) Do not exert excessive force when connecting the connector. Slowly connect with both
hands.
<Installation of Optional Products>
◈
VGA Water Block Installation
Connect the CPU Water Block and the VGA Water
Block with the PVC Tube and fasten them with Tube
Clamps as shown in the diagram.
Note 1) Using Needle-Nose Pliers for fixing the Tube
Clamps in place will make the installation easier.
- VGA Water Block and Reserator
’
s Base IN Connection
1) Connect one end of the PVC Tube to the Fitting of the VGA Water Block and fasten
with a Tube Clamp as shown in the diagram.
2) Pull out the PVC Tube through the I/O Bracket hole on the computer case.
3) Connect the Quick Coupling Insert that has been disconnected from the Degassing
Tube to the other end of the PVC Tube, and fasten it with a Tube Clamp.
4) Plug the Quick Coupling Insert into the Quick Coupling Socket of the Base IN fitting.
RESERATOR XT
Cord Bushing
I/O Bracket Bolt
Bolt
4-Pin Connector
DC Cable Connector
PVC Tube
VGA
Water Block
Base IN, Quick
Coupling Body
I/O Bracket
RESERATOR XT
5.4 CPU Water Block Installation (ZM-WB5)
1) Refer to the manual provided with the ZM-WB5 for installation.
2) If interference occurs while installing the Water Block, then stop the installation.
5.5 CPU Water Block and Reserator
’
s Base IN Connection
1) Connect one end of the PVC Tube to the Fitting of the CPU Water Block and fasten
with a Tube Clamp as shown in the diagram.
2) Pull out the PVC Tube through the I/O Bracket hole on the computer case.
3) Connect the Quick Coupling Insert that has been disconnected from the Degassing
Tube to the other end of the PVC Tube, and fasten it with Tube Clamp.
4) Plug the Quick Coupling Insert into the Quick Coupling Socket of the Base IN fitting.
English
5.6 CPU Water Block and Reserator
’
s Base OUT Connection
1) Connect one end of the PVC Tube to the CPU Water Block Fitting and fasten with a
Tube Clamp as shown in the diagram.
2) Pull out the PVC Tube through the tube hole of the I/O Bracket.
3) Connect the Quick Coupling Insert to the other end of the PVC Tube, and fasten with a
Tube Clamp.
4) Plug the Quick Coupling Insert into the Quick Coupling Socket of the Base OUT fitting.
Base IN, Quick Coupling Body
Base OUT, Quick Coupling Body
11
•
The specifications of this product and its components may change without prior notice to improve performance.
12
•
The specifications of this product and its components may change without prior notice to improve performance.
Summary of Contents for Reserator XT
Page 1: ...English Version...
