(See Figure 12)
Align the motor tray with the nose. Make sure that the motor tray is
centered over the center line at the trailing edge. Attach the motor tray with a strip of
fiber tape on each side. Cover the servos with strips of color tape.
(See Figure 12)
Peel the protective paper off of the hook side of two 1” squares of
Velcro. Stick the strips to the battery 1/2 inch from each end. Press the loop side to the
hook side and peel the paper. Press the battery in place with the sticky side down.
(See Figure 12)
Cut the two 1” square Velcro pieces into four 1/2” x 1” pieces. Stick
the hook side of one of the strips of Velcro to the nose of the motor tray. Stick the hook
side of one of the strips of Velcro to either side of the back of the motor tray. Put the
loop side of the Velcro loop side down on the hook side. Peel the paper off of the loop
side. Place the canopy over the motor tray, nose first. Spread the back end of the
canopy and lower it onto the motor tray.
Velcro
Battery
page 11
Velcro
Tape the tray down
with fiber tape
Cover the servos
with color tape.
Figure 12
