(See Figure 11)
Attach the motor to the tray with a tie wrap. Locate the dimples on the
rails on either side of the motor mount. Spin an X-acto blade in the dimples to make a
hole. Elongate the holes to fit the wire tie. Push the wire tie through from the top of the
tray. Wrap the wire tie under the motor tray and through the hole on the opposite side.
Set the motor in the motor mount and push it back against the stop. Thread the wire tie
and pull it tight. Hold the tail of the wire tie with pliers and give it a good strong tug. Trim
the tail off of the wire tie. Slide the wire tie connection to the side of the motor.
page 10
RECEIVER
RED DEANS ULTRA PLUG
RIBBON WIRE FROM ESC
TO RECEIVER
RED WIRE
ESC
Figure 11
WIRE TIE
