Zaehl CSX-11 DCPLR, Assembly

Page: 1 / 3

Michael Zaehl ▪ Elektronik-Tontechnik ▪ Odenthaler Strasse 47 ▪ D-51465 Bergisch Gladbach
phone +49 2202 863901 ▪ fax +49 22202 981915 ▪ info@zaehl.com ▪ www.zaehl.com
ELEKTRONIK TONTECHNIK
Assembly of profile set „CSX-11 DCPLR“ to RIEDEL DCP-1016E from year of
manufacture 2006
Important: All procedures described in the following have been carried out and tested by us. Nevertheless we do
not guarantee for errors nor completeness and do not take over liability of any consequences arising out of
following these instructions.
“CSX-11 DCPLR” profile set is mounted permanently to a RIEDEL DCP-1016E. It is needed as mechanical base
to assemble a CSX-11.
Required modifications of DCP1016E
1. Two holes D=4,5mm in front panel
2. Two holes with insert nuts M3 in chassis hood
3. Two countersinks D=6mm in rear panel
Procedures:
A. Holes in front panel
two holes D=4,5mm
30,7mm from top edge, 7mm from side edge
B. Coutersinks on rear panel
Remove the two (raised head) screws on the back panel and apply countersinks with an outer diameter of 6mm as
shown above. Replace both screws by the countersunk head screws supplied with the profile set.
Reason: The originally mounted (raised head) screws would get in the way when mounting the profiles.
7
30,7