DOC-USR-0109-03
___________________________________________________________________________________________
Z3 Technology, LLC
♦
100 N 8
th
ST, STE 250
♦
Lincoln, NE 68508-1369 USA
♦
+1.402.323.0702
52
Output Setup
Output Format
RTP
UDP
TSRTP
TSFILE
FILE
MPTS
Output format of encoded stream.
If UDP is selected, check the value of TS
Rate to make sure it is in line with
expectation.
TSRTP allows for streaming and recording to
TS file simultaneously.
TSFILE will write audio and video to a TS
file. If this is selected, type the path/name
of the file in “Dest Address” (Ex: to write to
a USB connected to the RPS:
/media/sda1/test.ts)
FILE will write raw .h264 and raw .aac to 2
separate files. If this is selected, type the
path/name of the H264 file in “Dest
Address” (Ex: /media/sda1/test.h264). If
audio is enabled, a companion .aac file is
then created (for example, for “test.h264” a
companion file “test_0.aac” is created).
MPTS can be used to encode one more
streams to DVB-ASI out. This is not
supported in the current release. Contact
Z3 for optional upgrade information.
Dest Address
(For all but MPTS)
x.y.z.w
(192.168.0.6)
IP address that the encoder is streaming to.
Dest Port
0 – 9999 (
5004
)
The port that the encoder is streaming to.
Aux TS File Enable
(UDP Only)
False
True
For UDP streaming only. If UDP is being
streamed, this allows the same UDP stream
to be saved to a ts file. The name of the
file is specified in “Aux TS File Location.”
Aux TS File Location
(UDP Only)
/tmp/aux1.ts
Appears if “Aux TS File Enable” is set to
“True.” Specifies where to save the TS file.
For example, if a USB drive is connected,
the value “/media/sda1/example.ts” could
be specified.
Video PID (UDP Only)
0 – 999 (
220
)
PID assigned to video in the TS stream.
