Z3-LEO-1X User Instructions
DOC-USR-0217-02
______________________________________________________________________________________
Z3 Technology, LLC
♦
100 N 8
th
ST, STE 250
♦
Lincoln, NE 68508-1369 USA
♦
+1.402.323.0702
47
8.8
Using Wi-Fi
The supported USB Wi-Fi card at the time this document was written is the TL-WN722N v2. If you find
that your card is not working as described in the document ssh in to the board (ssh
and run lsusb at the prompt. You should see this entry:
Bus 003 Device 002: ID 2357:010c
If you don’t see this entry the device you are using is not currently supported. Contact Z3 Technology
for support options.
8.8.1
Initial Wi-Fi Setup
(1)
Power down the encoder and plug the Wi-Fi adapter into the USB slot on the application board. Then
power on the encoder. The device will boot up and you will see the green indicator LED on the Wi-Fi
stick flashing.
(2)
If there are no saved networks or none of the saved networks are currently available the device will
enter Access Point (AP) mode. In this mode it will create a wireless network from the product name
and ethernet mac address of the
unit. The default password for this network is “z3password”. To
connect to this network, connect to the network from your PC.
Figure 46 Password Entry Screen
