19
CONFIDENTIAL
DOC-USR-0045-05
____________________________________________________________________________________
Z3 Technology, LLC
♦
100 N. 8th St. STE 250
♦
Lincoln, NE 68508-1369 USA
♦
+1.402.323.0702
7.5
Ensure Your PC has a Proper IP address
(11)
Note the IP address and netmask shown in the menu (default value is 192.168.81.68 and
255.255.0.0).
(12)
To be able to communicate with the Z3-DM8169-4K-RPS, the PC that you are communicating from
needs to have at least the same first 2 parts of the IP address. For example, if the board has an IP
address of 192.168.81.68, your PC would need to have an address of 192.168.x.y, where x.y is
anything but 81.68 (and not conflicting with whatever is on your current network). Ensure that this
is the case. If necessary, use the “P” and “N” options in the RPS menu to modify the address /
network mask of the board to conform to your network. Note that the first 2 parts being the same
are based on a netmask of 255.255.0.0. If netmask were 255.255.255.0, then the first 3 parts of
the IP address would have to be the same.
7.6
Run the Web Interface to Configure and Start Encode
(13)
In your PC, run a web browser (for best results, Z3 recommends FireFox or Chrome). In this
browser, type the IP address of the board noted in step (9) (for example, if the default value is
used, it would be http://192.168.81.68). After about 3 seconds, the System Setup menu should
come up:
(14)
Confirm that the mode is “Encoder Ultra HD.” If it is not, select “Encoder UltraHD” as the operating
mode in the lower right corner.
Figure 8 System Setup Tab
