CONFIDENTIAL
DOC-USR-0011-04
___________________________________________________________________________________________
Z3 Technology, LLC
♦
100 N 8
th
ST, STE 250
♦
Lincoln, NE 68508-1369 USA
♦
+1.402.323.0702
21
(27)
At this point you can find the new IP address assigned w/ DHCP by looking at the Serial UI:
(28)
You can go back to Static IP by unchecking “Use DHCP” and saving that to the user settings.
7.10
Dynamically changing bit rate / frame rate
It is possible to change two parameters in the middle of an encoding session:
(1) Video Bit rate
(2) Frame Decimation
To change these, simply enter the new desired value and then click the “Start Encoder” button.
The web page will respond with the following message:
Status: Changed rate
The video stream will then continue uninterrupted with the new parameter.
7.11
Tuning for Latency
For latency, the key parameter to work with is Video Burst Size.
Video Burst Size defines the number of milliseconds of buffering the encoder has to work with. The
higher this value, the more buffering it has to work with and the more time it has to “smooth things
out” for challenging content. However, a higher value also causes latency to increase accordingly.
To minimize latency, this value should be set to the lowest possible value. The lowest value Z3
recommends is 150.
The figure below shows the suggested values for Video Burst Size for three common use cases:
Maximum Delay
Case 1: Highest Quality, Highest Latency
2000
Case 2: Good Quality, Standard Latency
1000
Case 3: Normal Quality, Lowest Latency
150
Figure 13 Finding DHCP-assigned IP Address in the Serial UI
Figure 14 Tuning for Latency
New IP Address
