CONFIDENTIAL
DOC-USR-0011-04
___________________________________________________________________________________________
Z3 Technology, LLC
♦
100 N 8
th
ST, STE 250
♦
Lincoln, NE 68508-1369 USA
♦
+1.402.323.0702
15
7.3
Set up the Terminal Window
(5)
If you are running from a Windows PC, run TeraTerm. Select
“Setup – Serial Port” and set the
following:
Port:
The serial port that is connected
Baud Rate: 115200
Data:
8-bit
Parity:
None
Stop:
1-bit
Flow Control: None
(6)
If you are running from Linux, type:
# sudo minicom –s
And then configure by doing the following:
-Select “Serial Port Setup”
-Ensure the right serial device is specified (typically “/dev/ttyS0”)
-Set option E (“Bps/Par/Bits”) to 115200 8N1
-Press <return>
-Select “Exit”
7.4
Power on the board
(7)
Connect the 12V power supply and turn the power switch on. You should see the board booting
up within the terminal window. The RPS Main Menu will appear:
Figure 5 Serial UI Main Menu
