HE2K-DCK-1X User Instructions
DOC-USR-0122-05
______________________________________________________________________________________
Z3 Technology, LLC
♦
100 N 8
th
ST, STE 250
♦
Lincoln, NE 68508-1369 USA
♦
+1.402.323.0702
73
Only)
leave this value at 250. Certain decoders may
require a value similar to the video delay. If an
issue is encountered with a specific decoder, try
setting this value to the same value as the video
delay.
Output Setup
Output Format
RTP
RTSP
UDP
TSRTP
TSFILE
RTMP
RTMPS
Output format of the encoded IP stream.
If UDP is selected, don’t forget to check the value
of TS Rate to make sure it is in line with
expectation.
RTP requires an SDP file for the receiver that
corresponds with the video codec used.
RTSP requires the use of the RTSP URL.
TSRTP causes streaming of TS over RTP. This format
is required for encoding with Pro-MPEG Forward
Error Correction (FEC).
RTMP is only supported with H264(AVC) selected as
the Video Codec.
Decoder URL
(RTSP/UDP/TSRTP
Only)
Shows the url for use in VLC (and others) to decode
the stream.
Dest Address
w.x.y.z
(192.168.0.6)
The IP address of the destination of the encoded
stream.
Multicast IP*
(RTSP Only)
w.x.y.z
(
225.1.2.3)
Used to specify the default multicast address for
video rtsp stream.
Dest Port
0 – 9999 (
8600
)
The destination port that the encoder is streaming
to.
Aux File Enable
TSFile
Set to MP4File to record the stream to an MP4 file.
