FV4K-1XA User Guide
DOC-USR-0268-03
______________________________________________________________________________________
Z3 Technology, LLC
♦
100 N 8
th
ST, STE 250
♦
Lincoln, NE 68508-1369 USA
♦
+1.402.323.0702
13
The FV4K-1XA assembly has multiple connection options. Here are the two primary configurations using
Figure 5:
Option 1: Sony FCB-EW9500H (or compatible) HDMI camera connected on HDMI KEL (J5) + Sony FCB-EV7520
LVDS (or compatible) LVDS camera connected on LVDS KEL (J7)
Option 2: Sony FCB-EW9500H (or compatible) HDMI camera connected on HDMI KEL (J5) + Composite (J9)
The Interface Front End PCB of the FV4K-1XA assembly (see Figure 5) has 2 30-pin KEL connectors that allow
a flexible ribbon cable to be used to connect the encoder assembly to block camera. For configuration
Option #1, the first KEL connector, labeled “J5”, is used for Camera1 which is
HDMI CAMERA ONLY
and the
second KEL connector, labeled “J7”, is used for Camera2 which is
LVDS CAMERA ONLY
. For configuration
Option #2, connect the primary Sony FCB-EW9500H HDMI camera to “J5” and the Composite secondary
camera is connected to the FV4K-1XA assembly via the Molex 1.25mm Connector labeled “J9” (see Figure 5).
The KEL cable (ordering part number: CBL-0028-01) and the Molex to BNC cable are sold separately.
Figure 5 Interface Front End PCB
WARNING: ONLY USE THE CORRECT KEL RIBBON CABLE PROVIDED BY Z3 TECHNOLOGY.
Using an incorrect cable can permanently damage the camera body.
(1)
Connect an Ethernet cable from
Ethernet
on the back of the camera to a switch, router or other
DHCP server on the same network as your Windows PC.
(2)
Connect the 12V power supply to
+12V
on the Encoder and plug into a power outlet.
If Power over Ethernet (PoE) is available, then no connection to the power supply is required.
It will take 15-30 seconds to boot.
Primary KEL
Connector -
HDMI (J5)
Composite input
(J9)
