Z-World XP8600, User Manual

Page: 91 / 99

XP8600/XP8900 Simulated PLCBus Connections s 91
BL1100
Connecting a Z-World expansion board to a BL1100 requires a special
cable. Fasten the cable’s 20-pin connector to headers J010 and J10 as
shown in Figure D-2. Pins 1 and 2 of the connector must hang over the
end of the headers. Fasten the cable’s PLCBus connector to header P1 or
P2 of the expansion board, observing the orientation of pin 1, as shown.
Figure D-2. Connecting BL1100 to Expansion Boards
Software for interfacing the BL1100’s PIO port to a PLCBus port may be
found in the Dynamic C
PBUS_LG.LIB
library.
Use an external power supply with expansion boards con-
nected to the BL1100. There is no provision in the special
cable to 24 V from the controller to header P1 or P2
on the expansion boards.
!
BL1300
Expansion boards may be connected to header P5 on the BL1300 using the
same special cable used to connect them to the BL1000 or to the BL1100,
as shown in Figure D-2. The first two pins of the special cable hang over
the end of header P5 as before. However, the wire leading to pin 1 on the
BL1300’s header P5 must be cut, and may then be used to 5 V
from an external source to the expansion board. Software from the
Dynamic C
PBUS_LG.LIB
library may be used.
Use an external power supply with expansion boards con-
nected to the BL1300. There is no provision in the special
cable to 24 V from the controller to header P1 or P2
on the expansion boards.
!
Pin 1
PA0 (J10:1)
PA1 (J10:3)
PA2 (J10:5)
PA3 (J10:7)
PA4 (J10:9)
PA5 (J10:11)
PA6 (J10:13)
PA7 (J10:15)
+5 V (J010:1) /STBX
A3X
A2X
A1X
D2X
D3X
D0X
D1X
+5 V
PIO
Signal
PLCBus
Signal
Picks up VCC, GND,
and PA0–PA7. Leaves
PB0–PB7 available.
J010
PLCBus
Connector
Note that the first two pins of this
connector must hang over the end of
the header. A 20-pin connector is used
because 18-pin connectors are not
available.
J10