Z-World RabbitLink EG2100, User Manual

Page: 36 / 48

32 RabbitLink (EG2100)
E.1 Configuration Commands
These commands are used to set network parameters and to password protect the RabbitLink.
set gateway <IP address>
This command sets the IP address for the gateway.
IP address
The IP address for the gateway in dotted decimal format. The factory
default is
10.10.6.1
.
set hostname <name>
This command allows the RabbitLink to be identified with a unique name, that may be up
to 40 characters long.
name
User-chosen string. The factory default is
RabbitLink
.
set ip <IP address>
This command sets the IP address for the RabbitLink.
IP address
The IP address for the RabbitLink in dotted decimal format. The factory
default is
10.10.1.100
.
set netmask x.x.x.x
This command sets the netmask.
x.x.x.x
This is the dotted decimal format of the netmask. The factory default is
255.255.255.0
.
set passphrase
This command will prompt for a passphrase twice to confirm that the passphrase was cor-
rectly entered. The characters are not echoed back as a security measure. As another security
measure, the passphrase is hashed before it is stored on the RabbitLink. Whenever a new
session starts with Dynamic C or the RFU, the user will be asked for the passphrase. It
should be as long as possible to increase security, up to the maximum length of 255 charac-
ters.