Page 4
3
GUI
This equipment can be controlled via the GUI provided. Here is the description of it.
1 Connect Gateway Dialog
8 Resets the Z-wave Chip
15 Send set basic ON
2 Start Inclusion
9 Send NIF in broadcast
16 Send set basic OFF
3 Abort Inclusion
10 Gets the Home ID
17 Security Layer selection
4 Start Exclusion
11 Node is in failure or not
18 Send the selected Command
5 Abort Exclusion
12 Remove selected node
6 Start Learn Mode
13 Replace selected node
7 Abort Learn Mode
14 Request Neighbor Update
The “DEVICE DATA” section displayed on the right side is used to display main information
of the system.
An exclamation mark icon may be displayed on NODES section to show the nodes which
are failing.
Note that, in case of necessity to send multiple bytes as a command parameter’s value,
please enter the decimal number separated by a blank space in between.
