14
scene successfully
Note1: This process will only remove the target device/EP from its
assigned scene but will not exclude it from the network.
Deleting a Scene
Step
Setup Key
LED Indication Status
1
Press
in Advance
Setup
•
The
“
OK
＂
light turns
on
2
Press
•
“
OK
＂
LED flashes
once and stays on
•
“
LED_A
＂
flashes
slowly
3
Select a scene number
from 1 to 16 (1-8 or
1-8)
•
“
OK
＂
LED flashes
once then turns off
•
“
LED_A
＂
off
•
Scene deleted from the
scene successfully
Note1: This process will only remove the scene devices/EPs from its
assigned scene but will not exclude it from the network.
Note 2: The above steps are needed if Z-URC
TM
550EU to be a
secondary remote controller and the Scene information mapping from
gateway / primary controller is unsuccessful.
Scene Operation
After the scene setup is done, you can trigger the desired scene via
scene control keys in front panel of the Z-URC
TM
550EU. (Figure 4)
The green
“
OK
＂
LED flashes when the operation is successful, and
the red ERROR LED flashes when it
’
s failed.
Figure 4 Scene Control Keys of the Z-URC
TM
550EU
Scene
Control Keys
