Group 2: Used for returned events.
Report type:
1.Basic Set
•
Failed or success in add/remove the node ID can be viewed
from Z-Wave
TM
Controller.
Notice 1:
Always RESET a Z-Wave
TM
device before trying to add it to a
Z-Wave
TM
network
Z-Wave
TM
Notification
After the device adding to the network, it will wake-up once per day in
default. When it wake-up it will broadcast the “Wake Up Notification”
message to the network, and wake-up 10 seconds for receive the
setting commands.
The wake-up interval minimum setting is 30 minutes, and maximum
setting is 120 hours. And the interval step is 30 minutes.
Press the tamper key once. The device will wake-up 10 seconds.
Z-Wave
TM
Message Report
When the Door/Window triggered the device will report the trigger
event and also report the battery status and temperature.
In default the device will using Notification Report to represent the
trigger event.
* Door/Window Report: (PA13-A)
When the Door/Window Open, the device will unsolicited to send the
report to the nodes in the lifeline group.
Notification Report (V4)
Notification Type: Access Control(0x06)
Event: Door/Window Open(0x16)
And after the Door/Window Close clear, the device will unsolicited to
send the report to the nodes in the lifeline group.
Notification Report (V4)
Notification Type: Access Control(0x06)
Event: Door/Window Close (0x17)
* Tamper Report: (PAT13-A, PAT13-B)
The tamper key pressed over 5 seconds. The device will into the alarm
state. In that state, if the tamper key be released, the device will
unsolicited to send the report to the nodes in the lifeline group.
Notification Report (V4)
Notification Type: Home Security (0x07)
Event: Tampering. Product covering removed (0x03)
* Temperature Report: (PAT13-A, PAT13-B)
When the Door/Window triggered or the temperature differential over 1
Fahrenheit (in default), the device will unsolicited to send the “Sensor
Multilevel Report” to the nodes in the lifeline group.
Sensor Type: Temperature (0x01)
Note: To disable send temperature report after the flood triggered,
please setting the configuration N0.5 bit5 to 1.
*** Temperature differential report ***
This function default is enabled, to disable this function by setting the
configuration NO.21 to 0.
In the default, when the temperature is changed to plus or minus one
degree Fahrenheit (0.56 degree Celsius), the device will report
temperature information to the nodes in the lifeline group.
4