10
CONFIGURATIONS
Doc# 27-0044UM Rev B Issued 7/13/2012
3.6 RE-INSTALLING TOP COvER OF ZX3 STATION
1. Place cover loosely onto
ZX3 station. When placed on
the station, make sure your
side flanges properly align with
the corresponding slots.
3. Use both hands to push the
top cover from the rear or the
unit.
4. When the top is firmly seated
onto the
station casing, turn the
attachment screws at the rear of
the top cover to secure .
2. Using one hand, push slightly
down on the front edge of the
top.
1. If there is a red light on the front panel
then a fan needs to be replaced
7. Lift and remove fan unit from fan assembly.
3. Lift and remove the air flow baffle.
5. Lift and remove the rear fan cover.
2. Using a Philips screwdriver, Remove
the three screws from the air flow baffle.
4. Using a Philips screwdriver, unfasten
the rear fan cover.
6. Disconnect the fan connector from the
circuit board.
3.5 REPLACING A FAN
