13
Doc# 27-0041UM Rev B Issued 7/13/2012
OPERATIONS
4.4 INSERTING ThE TRANZPAk2 STORAGE MOdULE
1. Raise the TranzPak2 module to the slot.
and insert into the docking bay .
2. Use your thumb to gently push on the
TranzPak2 thumb plate until the module
is seated against the rear connector.
3. Press the locking handle until it snaps
into place.
4.3 REMOvING ThE TRANZPAk2 STORAGE MOdULE
1. Slide the locking catch towards the right
to allow the locking handle to spring open.
3. Push the locking handle to the left.
This will disconnect the TranzPak2 from
the rear connector.
4. Gently but firmly begin to pull the
TranzPak2 module out as it slides off the
grounding contacts.
5. When the TranzPak2 module is fairly
extracted, lift and support the module
away from the ZX2.
2. The locking handle will swing out.
