12
zcentral.zcorp.com
8. Replace a Print Head
For more details on performing these steps, refer to the
Addi-
tional Operations
section of the
Hardware Manual
for your
printer.
1.
On the Control Panel select
BUILD CHAMBER
, then
LOWER PLATFORM
. Lower the build platform about 6
inches below the top.
2.
Select
PRINT HEAD
then
CHANGE PRINT HEAD
on
the LCD menu. The fast axis moves to the service position.
3. Open the printer top cover.
Open the carriage cover and lift
the print head out of its slot.
Properly recycle or dispose of
the empty cartridge.
4. Using a paper towel damp-
ened with distilled water, clean
the carriage as appropriate for
your printer. Dry with a clean paper towel.
5.
Using an alcohol snap swab, clean the pogo pins for that
head. Use additional swabs if needed.
6.
Remove the new printhead from its packaging.
Be sure to
pull the tape tab off of the new printhead.
7. Insert the new printhead.
Press down firmly on the top of
the printhead, on the same side
as the pogo pins, to securely fit
the printhead into its slot.
8. Close the carriage cover by
pressing down until you hear it
click shut. Be sure the latch is
engaged.
9.
Close the printer top cover. Select
CONTINUE
then
EXIT
on the LCD.
