Z-Light 6TX/16TX/26TX Intelligent Direct Modulated Optical Transmitter
www.z-band.com
All Rights Reserved © 2018 Z-Band Technologies, LLC.
Phone: (866) 902-2606
- 18 -
FAX: (717) 249-3253
NOTE:
Any contamination of optical connector
can significantly degrade optical link performance.
This degradation will most likely manifest itself as
poor signal-to-noise (SNR) performance.
4.3.4 Connecting the Ethernet Cable
You can connect the Z-Light 6TX/16TX/26TX
to your TCP/IP LAN network in order to
monitor and control the transmitter remotely. After you complete the installation
procedures described in this chapter, you can use a network management system (NMS) to
monitor and control the Z-Light 6TX/16TX/26TX.
To connect the Z-Light 6TX/16TX/26TX, you must use a shielded and grounded Category
5 Ethernet cable.
To connect the Ethernet cable:
1. Connect an Ethernet cable to the transmitter’s RJ-45 Ethernet port. The Ethernet port is
on the rear panel of the transmitter.
2. Verify that the green Link LED is illuminated, indicating that there is a connection.
4.3.5 Connecting Power
The Z-Light 6TX/16TX/26TX
is normally shipped from the factory as a 110/240VAC
redundant power model. After mounting the Z-Light 6TX/16TX/26TX
in a rack, follow
the power connection procedure below for the model that you are installing.
It is equipped with two 110/240VAC switching power supplies that require input voltage
of 110
～
265VAC, at 50
～
60Hz single phase. The AC power plugs and switches are located
on the rear of the unit.
Follow all safety precautions detailed earlier in this manual. Prior to powering on the
equipment: ensure that the laser switch key is on “OFF” position before power on. After
the unit passes self-test, rotate the key to “ON” position according to the displayed message.
Turn on the power sources (for both power supplies). It takes about 60 seconds for all
systems to complete self-test and then to boot up into full operation.
