GSM/CDMA/WCDMA VoIP Gateway
YX Technical department
~ 11 ~
3.2 Equipment IP Address
The default IP of GoIP Gateway WAN port is 192.168.1.10, while the default LAN port IP is
10.10.10.1(The Version not up the LAN port).
3.3 Equipment Connection
Follow the steps below to install the GoIP Gateway to Network.
1) Fix the antenna to the GoIP Gateway. (Optional)
2) Insert SIM card(s) to slots.
3) Connect an Ethernet Cable to the WAN port of GoIP Gateway. The other end of the
Ethernet Cable should be connected to Network port of route or switch.
4) Connect an Ethernet Cable to the Network port of GoIP Gateway. The other end of the
Ethernet Cable should be connected to PC or other network device. (Optional)
5) Plug in the GoIP Gateway.
3.4 LED Indicators
There are a set of LED lights in the front of GoIP Gateway. Lights will be on or glittering when the
GoIP Gateway is power on and running. The following table describes various meanings of status
corresponding to LED lights in different display color.
Power
It indicates whether the system is running or not.
Calling
It indicates which module is calling.
Chosen card
It indicates was chosen.
4 Web Settings
This chapter describes how to set up GoIP Gateway through Web Page. There is a built-in web
server which can be accessed at URL: http://GATEWAY_IP/, while GATEWAY_IP is the WAN IP
address of the GoIP Gateway, such as 192.168.1.10.
As an example, the following introduction will base on the GoIP Gateway with WAN IP
192.168.1.10.
4.1 Login
First, connect a computer to the same LAN with GoIP, add the GoIP IP segment in the
computer.
