Charging Pile Instructions-V2.0
24
Figure 9.3.1.6
4.
Charging Connector Selection
Following step 3, choose the charging connector used to charge and reliably connected with
the vehicle. After connector choosing finished, the current choosing vehicle connector
number will be displayed on the screen. Connectors that not connected with the vehicle or
in fault state could not be chosed. See figure 9.3.1.7.
If start mode is set as “By card”: Click “next” to enter card swiping page, see figure 9.3.1.8.
Make sure informations of vehicle connector number, IC card number, etc are correct. Then
put the card in card swipping area to start the charging process and system will enter
charging information displaying page (see figure 9.3.1.9). If wrong information found,
please click “prev” at the bottom or “back” at the top right to rechoose charging mode and
then swipe the card.
If start mode is set as “By button”: Click “next” and charging pile will start the charging
process directly and system will enter charging information displaying page (see figure
9.3.1.10).
