Position the H920 PLUS above the landing area. Slowly lower the left-hand stick to
below the center position. The H920 PLUS will slowly descend and land. After the
H920 PLUS lands, depress and hold the START/STOP button for approximately two
seconds to stop the motors. Alternatively, activate Home Mode and the H920 PLUS
will automatically fly back to the home point and will land within 8m/26’ diameter
circle around the Ground Station.
WARNING: Always land as soon as possible after the first level low voltage battery
warning, or land immediately after the second level low voltage battery warning. If at
any time the Aircraft Battery Voltage shown on the screen is below 21.7V, land the
H920 PLUS immediately.
AFTER LANDING — ALWAYS turn off the H920 PLUS BEFORE turning off the ST16.
Then remove the battery(s) from the H920 PLUS and allow it to cool to ambient/room
temperature before recharging.
CONTROL RATE SLIDER
The Proportional Control Rate Slider, located on the right side of the ST16 Ground
Station, allows the overall climb/descend and directional control rates to be
controlled. Use the slow (turtle) position for the
lowest control rates (best for first-time pilots and
required when flying between 5000 feet and 8000 feet
Above Mean Sea Level), and use the high-speed
(rabbit) position for the highest control rates (best for
experienced pilots and can only be used when flying
below 5000 feet MSL). Speed is variable between
Slow and Fast modes.
19
CENTER: Press CENTER to set the current flight position of H920 Plus as the center of a circle.
START: Press START, and slide the icon, push the aileron stick to the right or left, H920 Plus will
fly around the circle center with distance between the Start point and the center point as the
radius.
BACK: Tap BACK to return to the previous interface.
NOTICE: Radius may be increased/decreased by pushing forward/backward on right stick.
NOTICE: Adjust the Throttle Control joystick to change the height of the aircraft, adjust the
Aileron Control joystick to change the orbit direction of the aircraft.
[ ] When the pilot tap the [ ]
，
the icon will become [ ]and the POI function will be paused.
When tapped again, the [ ] will become [ ], the copter will continue the POI function. Exit
the function by tapping the EXIT icon or switching flight mode.
POI: Point of Interest allows the pilot to select a subject to be orbited and have H920
PLUS autonomously orbit that subject.
Summary of Contents for H920 PLUS
Page 1: ...V3 0 ...