Revised 04/04/08
ALLURE Outdoor Install Apr08
Page 14 of 19
Commissioning
When installed the installer should operate the YUNCA ALLURE OUTDOOR to ensure that all
features are operating correctly, refer below.
Turning on your YUNCA ALLURE OUTDOOR fire
The markings mentioned below are imprinted on the Control
Panel Grill and are visible when the hearth panel is lifted out (NB.
You do not need to remove the hearth panel to light the fire).
Some models may have a black box behind the control panel grill
with similar markings, however the method of lighting is the same.
1. Push the control knob fully in and turn anti-clockwise (left) to
the “Ignition” position (you will feel a slight resistance), hold in for 5-15 seconds.
2. Continuing to hold it in, turn the knob further anti-clockwise to pilot mark (you will hear a
click).
3. When the pilot is lit, continue holding in the knob for about 20 seconds to allow safety
thermocouple to heat up.
Slowly
release the knob and the pilot flame should remain lit. If it
goes out repeat steps 1 - 3.
4. The control knob can now be turned further anti-clockwise (left) to the ON position to light the
fire. Adjust flame height and heat output as required.
Turning off
1. Turn control knob clockwise to the off position.
2. Turn fan switch to off position (centred).
