Step 5-
Fix the dome to the wall bracket, by tightening the screws, as shown in Fig 1.7.
Cautions- Remember to use the washers supplied, with the screws during this step.
Fig 1.7
Fig 1.8
Note:
Complete all the wiring connections before you power up the speed dome camera.
This section explains how to wire a single speed dome camera, making it simple to install, test and demonstrate
the camera. When using this product for the first time, please read carefully and follow this electric wiring drawing
as incorrect wiring may lead to permanent damage of the speed dome device or damage to other equipment.
Make the electrical connections to power the camera and the RS485 connections if you are using this camera with
the EVS2KB controller (see Page 15 onwards for details).
Single Speed Dome
Installation Tip
Before fixing the speed dome permanently in position make sure that the baud rate, protocol and camera ID
are all set. Connect to a controller and test that the main camera functions are working correctly. See Camera
Testing on Page 11
Camera- Wiring Diagrams
8
