Yuchai YC310LC-8, Operation Manual

Page: 29 / 184

Workplace Safety
To have a prior knowledge of your work area, you should inspect:
1. Position of the slope
2. Ditches
3. Falling or hanging objects
3. Soil conditions (soft and hard)
4. Water and marsh areas
5. Rocks and stumps
6. Boundaries of the buried foundations, pillar
and the wall
7. Boundaries of the buried waste and filling soil
8. Holes, obstructions, mud or water
9. Traffic
10. Thick dust, smoke and fog
11. Exact location of the buried or suspended the lines of electricity, gas, telephone, water, sewage
and other utility lines. If necessary, please let the unity companies mark, shut down or relocate
these facilities before starting work.
12. When working inside the building, please know clearly the clearance of the head, porch, and aisle
and so on, as well as the load-bearing capacity of the tunnel and floor. The things you do not know
may hurt you. Indoor operations must have adequate ventilation.
13. Know the precise distance between the cable, telephone and the machine, the machine and the
ground. If possible, it’s better to cut off the power. If you cannot do this, please request the
guidance of the signal member.
14. Make sure that keep the machine the statutory minimum distance from the underground gas pipes,
cables, telephone lines and water pipes.
15. Do not operate this machine in the culvert or under the ground.
16. Do not operate this machine where there are hazardous chemical substances.
17. Do not operate this machine in the explosive place.
Warning: Please contact the local unity service systems and departments before
the start of digging project.
Warning: Touching or approaching the power or the machine connected with the
power can cause electric shock. Do not let any pat of the machine close to the air
supply lines, unless the necessary safety precautions have been taken. Be careful
please.
Warning: If you look inside through the damaged cable, the cut fiber can seriously
hurt your eyes.
2-13