Yuasa MDX-617, Instruction Manual, Page: 12 / 20

•
12
•
YUASA Warranty Test Results
Besides the standard battery test results (see below)
Yuasa warranty test
has
one that differs:
CHARGE & RETEST Fully charge the battery and retest. Failure
to fully charge the battery before retesting
may cause inaccurate results. If CHARGE &
RETEST appears again after you fully charge
the battery, replace the battery. For charging the
battery use a YUASA approved type of charger.
Battery Test Results
Decision Interpretation
GOOD BATTERY Return the battery to service.
GOOD-RECHARGE Fully charge the battery and return it to service.
CHARGE & RETEST Fully charge the battery and retest. Failure
to fully charge the battery before retesting
may cause inaccurate results.
If CHARGE &
RETEST appears again after you fully charge the
battery, replace the battery.
REPLACE ADVISED Replace the battery and retest. A REPLACE
ADVISED result may also mean a poor
connection between the battery cables and the
battery. After disconnecting the battery cables,
retest the battery using the out-of-vehicle test
before replacing it.
BAD CELL-REPLACE Replace the battery and retest.
24 VOLT SYSTEM
24-volt system detected. Disconnect batteries
and test individually.
READY TO INSTALL Battery has just been activated and is ready to
install in vehicle (Motorcycle only)
NEEDS CHARGE Fully charge battery and retest using BEFORE
DELIVERY. (Motorcycle only)
Failure to fully charge the battery before
retesting may cause false readings.
New Battery Test Results
Besides the standard battery test results
new battery
has two more:
CYCLING REQUIRED Battery needs to be cycled for optimal
performance.
REST & RETEST Battery could have a surface charge, because it
has recently been charged.