20
Boss X-series
Instructions for use
21
youngmangroup.com
4.9 Battery chargIng - contInued
To charge the battery, follow the steps below:
a.
Depress the emergency stop button on
the handset control unit and remove the
key.
b.
Remove the cover from the charging
connection point. as shown in figure 1
below.
Figure 1
Figure 2
c.
Connect either the 240 volt or 110 volt
lead (dependent on the mains supply)
to the BoSS X-Series machine charging
connection point, as shown in figure 2
above. These cables are to be found in
the charging cable and guardrail tools
tray under the step up to the platform.
d.
Connect the mains lead to a suitable
power supply (either 110 volt or 240 volt)
e.
Whilst the battery is charging to 80% of
capacity the second light will be flashing
as shown in figure 1 below and when
the charging of the remaining 20%
is underway the third light will begin
flashing as indicated in figure 2 below.
Figure 1
Figure 2
f.
When the battery is fully charged all four
lights will illuminate after approximately
10 hours.
The BoSS X-Series machine should be stored
inside in a secure, clean and dry environment,
the emergency stop on the handset depressed
and the key removed. It should not be stored
outside.
When the BoSS X-Series machine is parked the
swivel castor brakes must be applied and if the
machine has to be parked on a gradient the
castors must be chocked. The BoSS X-Series
machine must not be stored where the air
temperature exceeds 50
o
C or falls below -20
o
C.
5.2 loadIng and unloadIng
The BoSS X-Series machine, with swivel castor
brakes applied, may be loaded onto a vehicle
by means of an adequately rated forklift using
the forklift points provided on the machine (see
pictures below).
WarnIng
The machine may be lifted from either side
using these points only and it must not be lifted
from either end. Ensure the forks are sufficiently
inserted into the forklift entry points.
Once located in the correct position on the
vehicle the BoSS X-Series machine should be
anchored by means of fully tightened straps
passed through the forklift access points.
5.1 storage
