Young ResponseONE 91000, Instructions Manual, Page: 12 / 18

Page 9
91000-90(B)
7.0 EXAMPLE SETTINGS
Suggested settings. Not all possible setting combinations are shown.
The
ResponseONE CONFIG
program is recommended for changing
setup parameters. See wiring diagrams for jumper settings.
7.1 FACTORY DEFAULT
RS-232 Enabled
RS-485 Disabled
Serial Output Format: ASCII
Output Interval 1000
Sample Count: 16
7.2 MINIMUM POWER
RS-232 Enabled
RS-485 Disabled
Serial Output Format: ASCII
Output Interval 1000
Sample Count: 16
7.3 HIGH WIND
Output Delay: 1000
Sample Count: 200
AVERAGE CURRENT DRAW AT 12V
Output Format
Output
Interval
Sample
Count
Baud Rate
(bps)
Average
Current Draw
(mA)
5 minutes 16 1200 4.5
5 minutes 100 1200 4.5
1 second 16 9600 8.4
1 second 100 38400 20.7
ASCII Polled 5 minutes 16 9600 5.8
1 second 16 4800 7.4
1 second 50 4800 12.4
0.25 second 16 9600 15.6
1 second 200 9600 34.2
Table Typical current draw per output format.
NMEA
ASCII
SDI-12 (polled)
RMYT
8.0 EMC COMPLIANCE
This device complies with Part 15 of the FCC Rules. Operation
is subject to the following two conditions: (1) this device may not
cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause
undesired operation.
This equipment has been tested and found to comply with the
limits for a Class A digital device, pursuant to part 15 of the FCC
Rules. These limits are designed to provide reasonable protection
against harmful interference when the equipment is operated in a
commercial environment. This equipment generates, uses, and
can radiate radio frequency energy and, if not installed and used
in accordance with the instruction manual, may cause harmful
interference to radio communications. Operation of this equipment
in a residential area is likely to cause harmful interference in which
case the user will be required to correct the interference at his own
expense.
This ISM device complies with Canadian ICES-001.
Cet appareil ISM est conforme à Ia norme NMB-001 du Canada.
EN55011/CISPR 11, Group 1, Class B device.
Class B equipment is suitable for use in domestic establishments
and in establishments directly connected to a low voltage power
supply network which supplies buildings used for domestic
purposes.
9.0 WARRANTY
This product is warranted to be free of defects in materials and
construction for a period of 12 months from date of initial purchase.
Liability is limited to repair or replacement of the defective item. A copy
of the warranty policy may be obtained from R. M. Young Company.
10.0 CE COMPLIANCE
This product has been tested and complies with European
CE requirements for the EMC Directive. Please note that shielded
cable must be used.