Orange
his is the Rearm wire. It provides you with a ( - ) pulse when
armed, after remote start, and then again one second after remote start
shuts down. As of August 2004, this wire’s output duration has been
increased by 1.0 second. This has been done to provide the Dome Light
Factory Rearm feature currently offered in the CM3000 controller module.
Some vehicles require the door to be open while the door is locked for the
factory security system to arm. Connecting this wire to the dome light circuit
Page 7
Pin #2 : Red/ Black
This wire is a
(-) 2nd Starter 200mA output
.
Normally the only vehicle this would be used on Nissan’s and older Ford’s.
You may connect this wire to the purple pigtail of the additional relay on
CN #1. This will result in a (+) trigger output for the 2nd starter on the blue
wire of the same relay.
Pin #3 : Violet
This wire is the
(-) Negative when armed out
. It will provide a
(-) output anytime the unit is armed or remote started.
This wire is pre-wired into the starter-kill. This wire could be used for adding
a window roll-up.
Pin #4 : Black
This is the
(-)Status Out wire (Ground when running).
It provides you with a (-) 200mA output as soon as the remote start is
activated.
This is the wire you would connect to a Transponder Module or maybe a
VATS module.
Page 6
Pin #5 : Blue
This wire will power (+)2nd Starter, (+) 2nd Accessory or (+) 2nd
Ignition depending on the jumper selection at JM1.
Pin #6 : Yellow
This wire is the
(+) Starter Output
.
Pin #7: Green/ Red
This wire is used to power the
(+) Ignition
.
This wire is also an input for the Young Shin Electronics,Inc. used to
monitor the status of the vehicle and for programming.
Pin #8 : Black
This wire needs to be connected to a chassis (-)Ground.
It is very important to make sure you have a good ground or the unit will
not function correctly.
Pin #1 : Red
This wire is used as the
(+)Constant Power
input for the unit.
This wire must be connected for the unit to function correctly.
Pin #2 : Green/ White
This wire is the
(+)Positive Parking
light output.
Connect this wire directly to the (+) trigger wire generally off the parking
light switch or found at or behind the fuse box.
Pin #3 : Red/ White
This wire is used as the (+)Constant Power input for
Starter and 2nd Ignition.
Pin #4 : White
This wire is used to power the (
+)Accessory
, which activates
the blower motor for the heater or A/C.
Pin #1 : Green/ White
This is the low voltage
(-) Parking light output 200mA
.
Some newer vehicles require a (-) parking light output instead of the
standard (+) output (reference connector #1) such as the new Jeeps and
even some Fords.
Pin #5 :
