YouKits TJ2B, Construction Manual

Page: 45 / 56

sequence is 1Hz, 10Hz, 100Hz, 1kHz, 10kHz, and 100kHz.
2) Buttons:
MOD - Mode switch. Press to select LSB, USB and CW (RX)
A / B - VFO Selection /Memory clearing. Press to select VFO A or VFO B. In MEM state,
hold the button until all of the memories are cleared.
V / M - VFO/MEM switching. Press to switch between VFO and MEM. Turn TUNE to select
the memory number.
MEM - Frequency saving/MEM to VFO transfer. Press to save the frequency to the
memory. Press MEM, the memory number appears. The dashes indicate the blank state
of the memory. Turn TUNE to select the MEM position you want to store the frequency into.
MEM00 - MEM39 can be used to store the frequency.
In MEM state, press MEM, VFO appears on the left corner. For example, VFO A may
appear on the left corner (Press A/B to select the VFO you want to transfer the memory to).
Press MEM, the frequency in the memory will be transferred to VFO A. Press V/M to
enter VFO A, and now you can see the transferred frequency.
3) Switches and sockets on the side
BATT - When the switch is set at this position, the internal battery is switched on, and the
rig works if the battery pack is installed.
OFF - When the switch is set at this position, the power is off. The rig stops working.
EXT - When the switch is set at this position, external power is on, and the rig works if 12V
DC is plugged in the 2.5mm DC socket.
CHG - Battery charging socket. The battery is charged no matter what position the switch
is set.
PH - Earphone/speaker socket. Either earphones or speaker can be used.