8)
Solder the 5-pin socket to CN2. This is the encoder and tuning rate port. Assemble
CN2 at the other side of the PCB, making it easier to run the cable.
Pins 1 - 3 are soldered to encoder pins 1 - 3 respectively. Pins 4 - 5 are soldered to the
two encoder switch pins.
The encoder pins are numbered as shown above. The center pin (Pin2) is GND. The
lower two pins are switch pins used as tuning rate selection.
Summary of Contents for TJ2B
