6
Audible Indicators
When the scanner is operational, the scanner provides audible feedback to
indicate the status of the scanner and the last scan. Eight settings are available
for the tone of the beep (normal, six alternate tones and no tone).
One Beep – On Power Up
When the unit powers up, the green LED turns on, then the red LED flashes and
the scanner beeps once. The red LED will remain on for the duration of the
beep. The scanner is now ready to scan.
When the scanner successfully reads a bar code, the red LED will flash and the
scanner will emit a beep (if configured to do so.) If the scanner does not beep
once and the red LED does not flash, then the bar code has not been
successfully read.
Three Beeps – During Operation
When placing the scanner in configuration mode, the red LED will flash while the
scanner simultaneously beeps three times. The red and green LEDSs will
continue to flash until the unit exits configuration mode. Upon exiting
configuration mode, the scanner will beep three times and the red LED will stop
flashing.
When configured, three beeps can also indicate a communications timeout
during normal scanning mode.
When using one-code-configuring, the scanner will beep three times: the current
selected tone, followed by a short pause, a high tone, and a low tone. The single
configuration bar code has successfully configured the scanner.
Razzberry Tone
This is a failure indicator. Refer to
Failure Mode Indicators
on page 8.
Three Beeps – On Power Up
This is a failure indicator. Refer to
Failure Mode Indicators
on page 8.
Summary of Contents for 5800
