12 |
P a g e
B. Operation by Remote Control
1.
Prior to use, the handheld remote control requires installation of one (1) coin-cell
battery.
2.
Remove the cover on the rear of the remote control by sliding backwards. Install the
batteries as shown and then slide the cover back into original position.
3.
To enable the remote control to function the power to the fireplace, it must be switch on.
4.
At a distance of 4 to 6 feet (1.5m to 2m.), point the remote control directly towards the
sensor.
A.
Infrared Window
B.
On/Off Switch
Press on/off switch to turn fire on.
C.
Flame Effect Dimmer
To operate press once to
commence dimming cycle. During the dimming cycle the fire
will slowly dim then brighten allowing user to choose
suitable level. Press a second time to stop cycle when the
desired level is obtained. Failure to press dimmer a second
time will result in the fire dimming then brightening cycle
repeatedly.
D.
Heater Maximum Heat (1350 W)
Press this once to
switch to high heat. The indicator light will come on as well
as the fan. Press again to turn off. (The fan will continue to
run for a few moments until sensors indicate cool condition).
E.
Heater Low Heat (675 W)
Press this once to switch to
low heat. The indicator light will come on as well as the fan.
Press again to turn off. (The fan will continue to run for a
few moments until sensors indicate cool condition).
F.
Indicator Lamps will verify current activity. If you are unsure if heat is on or off check
the lamps on the control panel. If the function is On, the indicator lamp will light above
the function switch.
