FORM 160.87-OM1
ISSUE DATE: 8/24/2018
JOHNSON CONTROLS
216
SECTION 5 - SERVICE
7. Press
key. The following steps will be per-
formed:
a. Erasing - During this procedure, the program
in the microboard Flash Memory will be
erased. A green bar reflects the progress of
this procedure. The red LED next to this bar
illuminates while this procedure is in prog-
ress.
b. Programming - During this procedure, the
program in the Program card is downloaded
into the microboard Flash memory. A green
bar reflects the progress of this procedure.
The red LED next to this bar illuminates
while this procedure is in progress.
c. Verifying - During this procedure, a check-
sum test is performed on the new program in
the microboard Flash Memory. A green bar
reflects the progress of this procedure. The
red LED next to this bar illuminates while
this procedure is in progress.
The microboard 7-segment LED Displays (U25
and U26) display the steps of the programming
process while they are in effect. During the Eras-
ing procedure, “Er” displayed. During the Pro-
gramming procedure, “Pr” is displayed. During
the Verifying procedure, “Ch” is displayed.
At the completion of the re-programming process,
if it is successful, “Flash Has Been Successfully
Programmed” is displayed and “Operation Suc-
cessful” is displayed in the Status Code box. Oth-
erwise, a message in the status box indicates the
step that failed.
8. Remove power from OptiView™ Control Center.
9. Remove Program card from Microboard connec-
tor J26 by lightly pushing the SD card in and then
releasing pressure. The SD card should pop out
slightly allowing for removal.
10. Reposition Microboard DIP Switch SW1 position
4 to OFF.
11. Apply power to the OptiView™ Control Center.
The re-programming procedure is now complete.