9
Remote controller
8.ON/OFF Button
4.CLOCK Button
3.TIMER Button
1.CODE Button
2.LIGHT Button
5.SLEEP Button
11.LOCK Display
13.SLEEP Display
14.Operation MODE Display
10.FAN SPEED Display
9.TIMER ON Display
6.TIME Button
7.MODE Button
12.SWING Display
Used to select CODE A or B
which will be displayed on
LCD.Please select A without
special explanation.
Control the lightening and
extinguishing of the indoor LED
display board.
20.TEMP Button
22.SWING Button
27.RESET Button
23.HEALTH AIRFLOW Button
25.SET Button
17.TEMP Display
15.SIGNAL SENDING Display
21.FAN SPEED Button
16.POWER/SOFT Display
18.TIMER OFF Display
19.CLOCK Display
24.POWER/SOFT Button
26.LOCK Button
If pressed,the other buttons will
be disabled.Press it once again,
lock will be cancelled.
When the remote controller
appears abnormal,use a sharp
pointed article to press this button
to reset the remote controller
normal.
Base Operation
Press ON/OFF on the remote controller, unit starts
1. Unit start
Press MODE button. For each press, operation mode
changes as follows:
Remote controller:
2. Select operation mode
Parts and Functions
NOTE:
Cooling only unit do not have displays and functions related with
heating. If the unit which you purchased has healthy function,
follow it. If not, please ignore.
Loading of the battery
Remove the battery cover;
Load the batteries as
illustrated.2 R-03 batteries,
resetting key(cylinder);
Be sure that the loading is
in line with the "+
/-
"
£»
Load the battery, then put on the cover again.
Note:
The distance between the signal transmission
head and the receiver hole should be within 7m
without any obstacle as well.
When electronic-started type fluorescent lamp or
change-over wireless telephone is installed in the
type fluorescent lamp or room, the receiver is apt
to be disturbed in receiving the signals,so the
distance to the indoor unit should be shorter.
Full display or unclear display during operation
indicates the batteries have been used up.
If the remote controller can't run normally during
operation,please remove the batteries and reload
several minutes later.
Hint:
Remove the batteries in case unit won't be in
usage for a long period.If there are any display
after taking-out, just need to press reset key.
