FORM 150.24-NM27
YORK INTERNATIONAL
97
LD02100
FIG. 34
ASSEMBLY AND WIRING
Parts
The following parts are required:
1. Weigh-Tronix IMP-24, Model 2600 printer.
2. 2.25" wide desk top calculator paper.
3. 25 ft. Twisted Pair Shielded Cable (minimum 3 con-
ductor), #18 AWG Stranded, 300V min. insulation.
4. (1 ea.) 25-pin Cannon connector and shell. Connec-
tor: Cannon P/N DB-25P or equivalent. Shell: Can-
non P/N DB-C2-J9.
Assembly and Wiring
All components should be assembled and wired as fol-
lows in Fig. 34. Strip the outside insulation back several
inches and individual wires about 3/8" to connect the
cable at the Micro Logic Board. Connect the shield of
the cable as shown on the Micro Logic Board. Do not
connect at the printer end of the cable.
Printer Configuration
2 Switches on the printer must be properly configured.
Remove the paper roll to access these switches. Place
the switches in the following position:
SW. 1 OFF
SW. 2 ON
Obtaining a Print-out
A print-out of current operating data may be obtained by
pressing the OPER DATA key. A snapshot will be taken
by the micro of current operating conditions. These con-
ditions will be stored in memory until they can be trans-
mitted to the printer and printed. A sample print-out is
shown in Fig. 23 on page 74.
A print-out of the fault shutdown history may be obtained
by pressing the HISTORY key. A print-out showing the
last 3 faults with all system conditions at the time of the
fault will be transmitted. A sample print-out is shown in
Fig. 24 on page 75.
Summary of Contents for YCWJ45EE0
