GENERAL
These condensing units are designed for outdoor installation
on a roof or at ground level and are manufactured under
ISO 9001 Quality System Certification.
Every unit is completely piped and wired at the factory and is
shipped ready for immediate installation. Only the liquid and
suction lines to the evaporator coil, the control wiring and the
main power wiring are required to complete the installation.
Each unit is dehydrated, evacuated, leak tested and pressure
tested at 450 psig (3132 kPa) before being pressurized with a
holding charge of refrigerant-22 for shipment and/or storage.
All controls are located in the front of the unit and are readily ac-
cessible for maintenance, adjustment and service. All wiring
(power and control) can be done through the front of the unit.
Refer to Tables 7 and 8 for condenser cooling capacities and
power requirements.
REFERENCE
This instruction covers the installation and operation of the ba-
sic condensing unit. For information on the installation and op-
eration of the evaporator blower units, refer to instruction Form
550.39-N4YI.
Renewal Parts:
•
Refer to Parts Manual for complete listing of replacement
parts on this equipment.
All forms may be ordered from:
Standard Register
Toll Free Telephone: 405-691-1126
Toll Free Fax: 405-799-7746
INSPECTION
As soon as a unit is received, it should be inspected for possible
damage during transit. If damage is evident, the extent of the
damage should be noted on the carrier's delivery receipt. A
separate request for inspection by the carrier's agent should be
made in writing. See Local Distributor for additional information.
Installer should pay particular attention to the words: NOTE, CAUTION and WARNING. Notes are intended to clarify or make the
installation easier. Cautions are given to prevent equipment damage. Warnings are given to alert installer that personal injury
and/or equipment damage may result if installation procedure is not handled properly.
MODELS H6CE090 & H4CE120
(WORLD 50 HZ)
®
INSTALLATION MANUAL
SUNLINE 2000
™
SPLIT-SYSTEM
CONDENSING UNITS
(AIR COOLED)
Supersedes: 035-15406-001-B-0404
035-15406-002-A-0504
CAUTION
THE ENCLOSED INSTALLATION INSTRUCTIONS AND ANY APPLICABLE
LOCAL, STATE, AND NATIONAL CODES INCLUDING, BUT NOT LIMITED
TO, BUILDING, ELECTRICAL, AND MECHANICAL CODES.
THIS PRO DUCT M UST BE INSTALLED IN STRICT COMPLIANCE W ITH
WARNING
OPERATION OF THE PRODUCT COULD CAUSE PERSONAL INJURY
O R P R O P E R T Y D A M A G E .
INCORRECT INSTALLATION MAY CREATE A CONDITION W HERE THE
HCE090
SHOWN
