•
When component soldering is complete, the module's front panel is the
non-copper side of the board.
For this reason, there is a decal sticker that
must be attached to the side without copper just before soldering the
connectors and any other through-hole element onto the board.
You should
cut some crosses using a knife in the indicated locations. For ease of assembly,
cut all excess pieces as shown below with a side cutter. Carefully affix the decal
to the non-copper side of the PCB. Take care to align the drilled holes with those
of the decal sticker. Proceed to place the connectors and other through-hole
elements through both the board and decal and finally proceed with the
assembly.
ASSEMBLY INSTRUCTIONS
RFLEGO Active Antenna Receiving Loop
page 15 of 66
