About YooFab
TM
electronic kit PCBs
•
Your printed circuit board is hand-produced using a high quality reliable method.
The copper is protected by a layer of vinyl that prevents oxidation which protects
the copper surface until it is ready to solder.
•
Remove all vinyl, as though it were a sticker. Please do not scratch or polish the
surface.
•
Optionally, and before starting to solder you can apply a few layers of lacquer
(hairspray) on top of the copper surface. Apply each coat of lacquer about 25 cm
away from the board and let dry for about 10 minutes. Apply the second coat
following the same procedure. And a third. This lacquer will protect the copper
from fingerprint stains, during the construction process, and it will also protect it
from future oxidation. This lacquer will
vaporize with the heat from the soldering
iron.
ASSEMBLY INSTRUCTIONS
RFLEGO Active Antenna Receiving Loop
page 14 of 66