1. Estimated battery lifespan is 3 years if the device runs 4 commends a day in average.
2. Batteries should be changed when LED diode stops flashing or receiving device stops reacting to commands.
3. When replacing the battery, pay attention to the correct polarity
Batteries contain substances that may be hazardous to health and may pollute the environment. Used batteries should
be disposed of properly.
Single-channel transmitter
(front)
5-channel transmitter
(front)
single-channel or 5-channel transmitter
(back)
1. Way of programming first transmitter depends on type of radio receiver. When programming first transmitter please follow
instruction of the device that is going to be controlled by the transmitter.
2. Longer than 5 seconds pause between series of button clicks during programming will cause device to switch off from
programming mode without saving any changes.
3. Programming transmitter using this method will result in deleting receiver memory.
4. Choosing ‘0’ group channel means remote controls all programmed devices on all channels at the same time. No
programming functions can be performed on group channel. All devices programmed to any other channel can be controlled
on group channel without additional programming.
Turn on power supply or press
microswitch (for 2 sec.) when
power is on.
Motor will make a sound.
Roller shutter will make
an up/down move.
Motor will
make a sound.
Press
programming button
(P2) on the remote.
or
Roller shutter
will make
an up/down move
and the motor will
make
a few short sounds.
Motor will
make a sound.
Press
programming button
(P2) on the remote.
Press
UP button
on the remote.
2
Pressing UP or DOWN button exits active channel selection mode.
Repeat the following procedure to set the number of active channels.
3. Active channel selection
4. Programming first transmitter to R-type motors
Press simultaneously and hold down the C
and CHANNEL- buttons. "C" symbol appears on the
display and than after 4 seconds it changes
to number 15 with up and down arrows.
Use the C or CHANNEL -buttons
to set the number of displayed channels.
Press the STOP key to confirm your choice.
The symbol "o" should appear.
UP button
STOP button
DOWN button
CHANNEL - button
C button
current channel
P2 programming button
battery
