1. For channel to work correctly when remote is set to automatic mode, it has to be activated. If automatic mode is
chosen for the channel and the channel number is flashing, that means device does not work in this mode.
2. Difference between automatic time of roller shutter opening and closing cannot be shorter than 32 minutes. In case of
smaller than minimal time difference fault message will appear and none of the changes will be saved.
3. Pressing UP or DOWN button in automatic mode will show currently set opening / closing time and symbol of current
process.
4. Estimated battery lifespan is 1 year if the device runs 4 commends a day in average.
5. Batteries should be changed when device stops reacting to commands.
6. When replacing the battery, pay attention to the correct polarity.
7. When on display all channels are selected remote controls all programmed devices on all channels at the same time.
No programming functions can be performed on group channel. All devices programmed to any other channel can be
controlled on group channel without additional programming.
8. For all devices, that are programmed on all the channels, to work at programmed time, group channel and automatic
mode should be chosen.
Weekly programator can be set up in 4 ways (opening and closing time for selected option):
- individual days
- MO-FR
- MO-SA
- whole week
Batteries contain substances that may be hazardous to health and may pollute the environment. Used batteries should
be disposed of properly.
1. Manual work mode: standard mode without using time programming function.
2. Automatic mode: standard mode with activated automatic work time.
3. Random work mode: automatic mode with random time of work (15 minutes difference from programmed time).
4. Work mode changes for all channels.
By pressing
programming button P2
for about 3 seconds work mode
will change to manual mode.
By pressing
programming button P2
for about 3 seconds work mode
will change to automaticl mode.
By pressing
programming button P2
for about 3 seconds work mode
will change to random mode.
Pressing the programming button P2
again switches between modes.
1. Each channel can be activated or deactivated in automatic mode.
2. If channel is deactivated transmitter will not control programmed radio receiver at preset time.
3. Channel is deactivated if its number is flashing.
4. In default mode all channels are active in automatic mode.
By pressing
programming button P2
for about 3 seconds work mode
will change to automatic
or random mode.
Choose the channel
by pressing L1 or P1 button.
By pressing P1 button
for about 5 secondsn channel will
deactivate in automatic mode.
Channel number is flashing.
Another pressing P1 button
for about 3 seconds
will activate automatic mode
on chosen channel.
Channel displays constantly.
3. Changing work mode
4. Activating channels in automatic mode
2
