11. Removing third limit position
5
1. In case of setting the limit positions, the upper or lower limit position can be corrected.
2. Longer than 2 minutes pause between series of button clicks during programming will cause device to switch off from
programming mode without saving any changes.
1. After setting the upper and lower limit positions, it is possible to set the third position (favorite) between those positions.
2. Hold the STOP button for 3 seconds to set the blind in third limit position.
9. Regulation limit positions
10. Programming the third limit position
REGULATION OF THE UPPER LIMIT POSITION:
REGULATION OF THE LOWER LIMIT POSITION:
Upper limit position
has been set.
An example of the third
limit position
Lower limit position
has been set.
Simultaneously
press and hold UP and STOP
buttons for 5 seconds.
Motor will make
a sound. Roller shutter
will make short
up/down movements.
Roller shutters will
make 2 short up/down
movements. Motor will
make several sounds.
We set the new
upper limit position.
Simultaneously press
and hold UP and STOP
buttons for 2 seconds
to confirm new upper
limit position.
Simultaneously press
and hold DOWN and STOP
buttons for 5 seconds.
Set the blind
in favourite position
Press
programming
button P2.
Motor will make a sound.
Roller shutter will make short
up/down movements.
Motor will make a sound.
Roller shutter will make short
up/down movements.
Roller shutters will
make 2 short up/down
movements. Motor will
make several sounds.
Press
STOP button.
Motor will make
a sound. Roller
shutter will make short
up/down movements.
Roller shutters will
make 2 short up/down
movements.Motor will
make several sounds.
We set the new
lower limit position.
Press
STOP button
Simultaneously press and hold
DOWN and STOP buttons for 2
seconds to confirm new lower
limit position.
Motor will make a sound.
Roller shutters will make short
up/down movements.
Motor will make a sound.
Roller shutters will make short
up/down movements.
Motor will make a sound.
Roller shutters will make short
up/down movements.
Press
STOP button.
Press
STOP button.
Press
programming
button P2.
