![background image](http://html1.mh-extra.com/html/yomani/ml/ml_owners-manual_3453080035.webp)
unrestricted
29
ymn_installing.fm
document release 2.2
last updated 3 May 16
YOMANI ML/XR
OWNER
MANUAL
Guiding cables when using a fixation plate
You can route the cables through:
•
the bottom cable opening in the fixation plate and a hole in the counter surface
To guide the cables through a hole in the counter surface, detach the cable opening
cover from the bottom cable opening and guide the cable through the hole you have
created.
•
the rear cable opening on the fixation plate
Attaching YOMANI to the fixation plate
1.
Make sure the cables have been routed through one of the cable openings in the
fixation plate, and that they are long enough to connect to the YOMANI before it is
attached to the plate.
2.
Place the terminal on the fixation plate as shown below.
Figure 34. Placing and locking YOMANI on fixation plate
3.
Push the terminal towards the back of the plate until it snaps into its locked position.
Removing YOMANI from the fixation plate
If you need to remove the YOMANI from the fixation plate:
1.
Carefully insert a flat object such as a screwdriver under the front of the terminal,
centrally.
2.
Raise the flat object slightly to press down the release lever, and hold the release
lever down while pulling the terminal towards you.
The terminal should shift about one centimetre
Summary of Contents for ML
